Friday, January 25, 2013

Flashback Friday: 5-23-2010, Day 40 of building R2-TD

R2 and I are heading to Lincoln NE today for a fund raising event. Also, I have a cousin graduating today in Lincoln so my whole family will be around today. None of them have seen R2 in person yet and I wanted to make the best impression I could. That meant lots of little detail work even if its just temporary. One of the things that bothered me about my last event was all the "holes". I got what parts in and covered the rest up with spare pieces of styrene. Its not perfect but looks better than a gaping hole for the photos today. Dawn and I also worked on getting my front vents built from the A&A kit. It wasn't as difficult as I thought it would be but the end result did not fit into my vent surrounds. I'll have to do some fine sanding but for now, just taped the vents in without the surrounds. I also got my short shaft struts painted and in place. It took a second try to paint as the weather was windy and I got in a hurry. You think I would of learned my leason after my dome painting troubles. LOL! 

I also did some temp work on the dome. I got the Front Logic and Rear logic displays in. For now I just taped the LEDs in so I wouldnt have a hole. I got my duel LED blinkers installed. For now I velcro'd a 9 volt battery inside the dome to run them. For a Flasher housing, I used a toilet paper roll and just taped it all into place. Its not pretty but has worked really well. We'll see how it holds up after todays events. I hope to have some of these temp things out by next weeks SAC event.

Heres some photos of how things turned out.







Friday, January 18, 2013

Flashback Friday: 5-20-2010, Day 39 of building R2-TD

Since I took today off for a garage sale that got rained out, it gave me some time to work on R2 today. I began putting on some of the parts I've recently gotten. Today consisted of horseshoes, Boosters, hubs, a front vent, the data port and a side piece. I'm on the fence about the black horseshoes. I havent added borders to the skin yet and I was thinking about painting those black also so things would blend a little better. Overall, I'm pretty happy with the way things are turning out.





Friday, January 11, 2013

Flashback Friday: 4-29-2010, Day 38 of building R2-TD

I had some decent weather the other day so I got to paint the skins. I painted the inter skin red to match the dome and left the outer skin white. The white matched up pretty good so I didn't paint it at all. Heres how it turned out. 



I tried to get what parts I have in but I need to modify some things first as they didnt fit.

Friday, January 4, 2013

Flashback Friday: 4-28-2010, Day 37 of building R2-TD

Brad, Steve and I finally got a moment to work with my A&A skins. It took a while to get everything ready to mount because those guys use every little piece of styrene for various parts. Each piece is taped down and came out very easy once the tape was removed. I already have some of the parts so I have extra pieces to use for reinforcement or a spare. 

We opted to staple the inter frame as its not likely to be removed. The outer frame is screwed on. We lined everything up with the top top of the frame but after doing it, I wish we should lined it up with the bottom. Anyways, heres some photos of R2 getting some skin! 

Here I remove all the tape and begin to pop out the pieces.

R2 before we begin

We test fitted to make sure everything fits.

Things are startingto look good.

We optedto staple the inter skins


I cut a back access door out of the back piece so I can access the batteries easier.

Things are looking good.

And R2 has skin... now to paint!